those old Holton 20" bell Monster-like E-flat tubas valveset BORE SIZE ?
Forum rules
This section is for posts that are directly related to performance, performers, or equipment. Social issues are allowed, as long as they are directly related to those categories. If you see a post that you cannot respond to with respect and courtesy, we ask that you do not respond at all.
This section is for posts that are directly related to performance, performers, or equipment. Social issues are allowed, as long as they are directly related to those categories. If you see a post that you cannot respond to with respect and courtesy, we ask that you do not respond at all.
-
bloke
- Mid South Music
- Posts: 19356
- Joined: Thu Aug 13, 2020 8:55 am
- Location: western Tennessee - near Memphis
- Has thanked: 3856 times
- Been thanked: 4110 times
those old Holton 20" bell Monster-like E-flat tubas valveset BORE SIZE ?
Does anyone have this spec ?
-
the elephant
- Posts: 3411
- Joined: Thu Aug 13, 2020 8:39 am
- Location: 404 - Not Found
- Has thanked: 1903 times
- Been thanked: 1346 times
-
bloke
- Mid South Music
- Posts: 19356
- Joined: Thu Aug 13, 2020 8:55 am
- Location: western Tennessee - near Memphis
- Has thanked: 3856 times
- Been thanked: 4110 times
-
the elephant
- Posts: 3411
- Joined: Thu Aug 13, 2020 8:39 am
- Location: 404 - Not Found
- Has thanked: 1903 times
- Been thanked: 1346 times
Re: those old Holton 20" bell Monster-like E-flat tubas valveset BORE SIZE ?
I ought to say that the one I have here is .650" but they might wiggle up to .656" like Olds. I think they were a little inconsistent over the years. I have heard of them mic-ing out at .660" too, but I have never actually *seen* that, personally.
