Beelzebub is one of my favorites. The solo, that is.
POLL: shorty/fatty (York-like) Holton B-flat tuba with 19-inch bell...
-
Doc
- Posts: 2472
- Joined: Thu Aug 13, 2020 9:48 am
- Location: Downtown Browntown
- Has thanked: 846 times
- Been thanked: 766 times
- Contact:
Re: POLL: shorty/fatty (York-like) Holton B-flat tuba with 19-inch bell...
- These users thanked the author Doc for the post:
- MN_TimTuba (Sun Dec 10, 2023 9:06 pm)
Welcome to Browntown!
Home of the Brown Note!
Home of the Brown Note!
-
Dents Be Gone!
- Posts: 596
- Joined: Thu Apr 06, 2023 5:13 am
- Has thanked: 166 times
- Been thanked: 147 times
.
I agree, guys. This is the way to go.
Last edited by Dents Be Gone! on Wed May 01, 2024 8:18 am, edited 1 time in total.
- These users thanked the author Dents Be Gone! for the post (total 2):
- Doc (Sun Aug 27, 2023 3:18 pm) • bloke (Wed Aug 30, 2023 9:23 pm)
-
bloke
- Mid South Music
- Posts: 19289
- Joined: Thu Aug 13, 2020 8:55 am
- Location: western Tennessee - near Memphis
- Has thanked: 3841 times
- Been thanked: 4088 times
Re: POLL: shorty/fatty (York-like) Holton B-flat tuba with 19-inch bell...
LOL...
I was looking through youtube videos to find crap to delete.
I found this (which seems like a good "delete" candidate), but it made me laugh, so it stays.
This is the 5th valve (FF semitone circuit) for this B-flat tuba before being mounted on the instrument.
I had some Jinbao 19mm bore rotors, and decided to NOT spend the dough on a Meinlschmidt...so I picked the best one that I had, and "worked" the rotor body up higher into the casing until I had more (a good bit of) contact area between the rotor body air seal surface and the casing.
I was looking through youtube videos to find crap to delete.
I found this (which seems like a good "delete" candidate), but it made me laugh, so it stays.
This is the 5th valve (FF semitone circuit) for this B-flat tuba before being mounted on the instrument.
I had some Jinbao 19mm bore rotors, and decided to NOT spend the dough on a Meinlschmidt...so I picked the best one that I had, and "worked" the rotor body up higher into the casing until I had more (a good bit of) contact area between the rotor body air seal surface and the casing.