Re: Cutting Thick Brass — SOLVED!
Posted: Sun Jan 16, 2022 6:43 am
Yep. Sometimes I too have to buckle down and just file & sand until I get a piece to look like I want.
I feel precisely 1.75382 smidgens less rednecky. HAHAHA!!!
TubaForum.net
Tuba & euphonium forum, message board, and community.
https://mail.tubaforum.net/
Cutting Thick Brass — SOLVED!
Page 2 of 2
Re: Cutting Thick Brass — SOLVED!
Posted: Sun Jan 16, 2022 7:16 am
Matt, it is a relief to know that someone of your skill level with a shop as well-outfitted as yours still has to physically "gut out" some operations, on occasion.
I feel precisely 1.75382 smidgens less rednecky. HAHAHA!!!
I feel precisely 1.75382 smidgens less rednecky. HAHAHA!!!
Re: Cutting Thick Brass — SOLVED!
Posted: Fri Jan 28, 2022 1:04 am
Not exactly the same, but the same idea:
I cut the raw piece with a jigsaw, then ground it to shape by eye on the bench grinder, then finished it with a lot of filing and sanding. The plate was formed with sheet brass and then hard soldered on.
It took a LOT longer than I wanted it to
Final product, adjusted a little:
- C4BF0DD0-F828-4733-9411-C6C8DFB9D76A.jpeg (105.06 KiB) Viewed 298 times
It took a LOT longer than I wanted it to
Final product, adjusted a little:
- E42CBB10-E0C1-4D61-8471-82C5610E71E5.jpeg (132.59 KiB) Viewed 295 times
Re: Cutting Thick Brass — SOLVED!
Posted: Fri Jan 28, 2022 9:42 am
Same joint exactly. Excellent!
