My pearl inlay popped out of my finger button last night - A FIRST FOR ME. I guess if you play long enough sooner or later you see it all.
Any particular glue I should use? Looks like something clear was used before. CB50 valve set.
TJ
glue finger button
Forum rules
This section is for posts that are directly related to performance, performers, or equipment. Social issues are allowed, as long as they are directly related to those categories. If you see a post that you cannot respond to with respect and courtesy, we ask that you do not respond at all.
This section is for posts that are directly related to performance, performers, or equipment. Social issues are allowed, as long as they are directly related to those categories. If you see a post that you cannot respond to with respect and courtesy, we ask that you do not respond at all.
-
Tim Jackson
- Posts: 217
- Joined: Thu Sep 17, 2020 9:16 pm
- Has thanked: 13 times
- Been thanked: 128 times
-
the elephant
- Posts: 3420
- Joined: Thu Aug 13, 2020 8:39 am
- Location: 404 - Not Found
- Has thanked: 1911 times
- Been thanked: 1358 times
Re: glue finger button
If the "pearl" is plastic I use a two-part epoxy, which works well and is pretty much permanent. If it is actually a genuine mother of pearl inlay then I would use Automotive Goop as you can remove the pearl if you need to, but it won't come loose and the MOP won't absorb it. (It can be rubbed off with some persistence.)
Goop
Epoxy
Don't use any form of "superglue". It does not work well in this application. Do not use Gorilla Glue, either.
Goop
Epoxy
Don't use any form of "superglue". It does not work well in this application. Do not use Gorilla Glue, either.
-
bloke
- Mid South Music
- Posts: 19396
- Joined: Thu Aug 13, 2020 8:55 am
- Location: western Tennessee - near Memphis
- Has thanked: 3866 times
- Been thanked: 4130 times
Re: glue finger button
It seems as though every type of glue has something about it against which one can argue, whether it’s brittleness, deterioration, water-solubleness, or loosening - due to heat.
This is why – in past decades – pearls were press-fitted and swedged into finger buttons - with a tapered steel device, rather than glued in.
Though hot glue it isn’t perfect - and can turn loose, when subjected to considerable heat, I tend to choose it, because it’s more flexible - as finger buttons are constantly subjected to vibration and pounding. There actually is a higher grade of it (yellow in color) that holds better at higher temperatures, and is more reluctant to release. MTS – the case manufacturer – uses the yellow stuff on their upholstery.
Good luck.
This is why – in past decades – pearls were press-fitted and swedged into finger buttons - with a tapered steel device, rather than glued in.
Though hot glue it isn’t perfect - and can turn loose, when subjected to considerable heat, I tend to choose it, because it’s more flexible - as finger buttons are constantly subjected to vibration and pounding. There actually is a higher grade of it (yellow in color) that holds better at higher temperatures, and is more reluctant to release. MTS – the case manufacturer – uses the yellow stuff on their upholstery.
Good luck.
