Page 1 of 1
quick solder questions
Posted: Wed Oct 04, 2023 1:58 pm
by arpthark
Do you guys typically prefer 50/50, 60/40, or something else?
Is 1/8" diameter "good enough" for most applications, or is that too thick?
Trying to get a feel for what the "Miraphone 186"
of the solder world is before I plop down a bit of cash.
Re: quick solder questions
Posted: Wed Oct 04, 2023 2:03 pm
by LeMark
Look up solder for stained glass windows, pretty sure that's standard
Re: quick solder questions
Posted: Wed Oct 04, 2023 4:13 pm
by Tubajug
I've got a spool of 70/30 from Ferree's that I've probably had for more than 10 years and I'm just now getting close to last coil of solder.
https://www.ferreestoolsinc.com/product ... oft-solder
Re: quick solder questions
Posted: Wed Oct 04, 2023 5:05 pm
by bloke
I used to think it mattered to me, but I've found that it doesn't, and that I (apparently...??) don't notice any difference.
I look around the web and find whatever is currently the least expensive.
I DO care about the diameter, and I DO care about the flux...Otherwise (I suppose...??) I just naturally adjust heat/timing.
Re: quick solder questions
Posted: Thu Oct 05, 2023 2:43 am
by TheBerlinerTuba
hey arpthark,
I would recommend a 60/40 or 70/30 solder around 1 to 1.50mm thick. Be sure that there is no "flux" or "acid core" in the solder.
Also, to go along with the solder, try the Nokorrod flux. This is one of the best out there.
As with any soldering, be sure to have good ventilation as there is lead present.
Re: quick solder questions
Posted: Thu Oct 05, 2023 9:00 am
by Tubajug
I've also known people to buy a spool from Hobby Lobby (in the stained glass area, like Mark mentioned) and it works just fine. They used to have a 40% off one item coupon, but I don't know if they do that anymore.
Re: quick solder questions
Posted: Thu Oct 05, 2023 9:44 am
by bloke
I can even use that thick no lead solder from the hardware store in an emergency, but I neither like no lead nor thick. Notice that our Berlin friend observed that two different alloys we're just fine, which sort of goes along with my post.
As far as that so-called plumbing solder is concerned, I got an entire sousaphone ready to put back together and refinish one time and realized that I had no solder. I put the whole thing together with that and to the best of my knowledge it's done fine to this day, and it's been quite a few years. I didn't have much fun sticking it together with that stuff, but it worked. I also use that stuff for repairing tiny cracks on crappy old school instruments whereby the band director has made it very clear that they just wanted to play for cheap. Actually, I've also used that plumbing solder to trace along spider cracks on first branches of sousaphones - sousaphones that probably should be thrown in the trash.
I'm not going to tell you about the crappy torches that I use. It's really more of a matter of experience and having a touch - I think - than having the very finest torches.